When mounting at an angle be sure to locate the studs to fasten the bar to and measure accordingly.
Vertical grab bar placement in shower.
Alternate roll in type shower compartments in alternate roll in type shower compartments grab bars shall be provided on the back wall and the side wall farthest from the compartment entry.
Near the toilet is another good place to install a grab bar.
And if the bottom of this bar is located lower than the side wall bar it provides a good extra grip for getting out of a tub.
You can mount a grab bar horizontally vertically and diagonally.
On the side wall.
Strength the push pull aspect of a vertically positioned bar caters to balance issues more than strength although strength issues are not totally left out.
This is normally a small grab bar positioned vertically.
Choose a bar 18 inches long or longer for vertical placement at the edge of the tub.
Again another small bar positioned.
Vertical grab bar requirements a vertical grab bar 18 455 mm minimum in length mounted along the side wall.
Grab bars shall be installed 6 inches 150 mm maximum from adjacent walls.
Vertical placement is best for stepping in our out of the tub.
Vertical placement especially meets the weakness that one might have standing up from a bench or chair in the shower.
They should be position in the following spots.
Grab bar and family handyman websites.
Choose bars that are 1 1 2 inches.
On the wall at the entrance to the shower stall.
This is usually a longer bar positioned horizontally.
The grab bar s shall be mounted 33 36 inches 840 915 mm above the shower floor measured at the entry.
Keep in mind that the goal of each bar placement is to create a handrail of sorts surrounding the bathtub.
Bottom of the bar located 39 990 mm minimum and 41 1040 mm maximum above the floor.
Center line of the bar located 39 990 mm minimum and 41 1040 mm maximum from the rear wall.
Vertical bars run up and down and typically are mounted at the entrance of the shower to stabilize a bather as he enters or exits.
All three directions can be used in the tub.
The controls and spray unit shall be within 18 inches 455 mm of the front of the shower.
Choose a bar 32 inches long or longer for a horizontal bar.
The vertical bar on the faucet wall steadies the bather when adjusting the water.
By the faucet handles or near them.
Vertical grab bar placement the grab bar can be mounted into a stud if located that sits behind the wall or optionally mounted using approved anchoring devices such as snap toggles flip toggles or securemount anchors when a stud cannot be identified in a convenient location.
Where a seat is not provided in standard roll in type shower compartments grab bars shall be provided on three walls.
The controls shall be placed in an area between 38 48 inches 965 1220 mm above the floor.
