Look for the end of the cord where it is tied in a knot.
Venetian blind cord lock stuck.
Remove old tilt cord by pulling it out.
Step 2 make sure that the cords can move freely.
If that still doesn t work you can manually disengage the cord lock.
Sometimes the cord can become lopsided or tilted after extensive use and affect how the blind functions.
Locate the cord lock mechanism in the headrail the lift cords run through this.
Pull the cord toward you and cut the knot off the end of the cord.
Look inside the head rail to find the lock mechanism.
You can do this with your hands and fingers.
Tilt cord is simply threaded over pulley and out again.
Lift the bottom of your blinds even if they are already stuck at the top near the headrail.
Take a screw driver and press the pawl down in the track in which it travels.
Untie or cut off knots at ends of tilt cord and remove pulls.
This occurs for a variety of reasons but you can typically lower the blinds using a manual method.
Set the blinds on a tabletop or countertop so that the lock mechanism with the open top of the head rail is accessible.
This pin holds the lock.
If the lock malfunctions the cord and blinds will become stuck in the raised position.
First hold your lift cords level with the headrail and gently pull.
Step 3 if the cords are stuck or jammed take a screwdriver or needle nose pliers and move the pin to free the cords.
Remove the cap covering the hole in the bottom rail of the venetian blinds.
To release the blinds tug the lift cords to the side pulling towards the center of the blinds.
Use these directions to replace a tilted cord.
Usually this extra support does the trick.
Use the flathead screwdriver to poke the pin inside the lock mechanism.
To do this carefully remove the blind from the window and lay it on a flat surface.
It doesn t connect with lift cord.
Grasp the side cord on the blinds and raise it upward until it is level with the top rail on the blinds.
It s important to have properly working cords on a venetian blind.
It has the blind s cords running through it.
If this does not work the pawl must be released follow these easy steps.
This should release the cord lock.
To help release the lock place your hand on the middle of the bottom rail and push up while simultaneously trying to unlock the blind cord.
If the cords still don t pull or adjust the height of your blinds then you may need to force the lock mechanism open.
If this does not fix the problem take your blind out of the window.
When tugging the cords to the center of the blinds doesn t lower the blinds remove the blinds from the brackets.
Lift up and out depending on your bracket configuration to remove the blinds from the window.
