Transport Fever Passing Siding

These trains can share a line or be on two separate lines.

Transport fever passing siding.

Passing siding configuration when a second train is added to this configuration both get stuck in the station. If a train passes a green signal indicating a free path ahead the path to the next signal or station is reserved for the train. Signals should be placed only in the direction of travel prior to the junctions on the double track portion of the line. Passing loop or siding passing loops allow two trains to share one track.

By passing another signal leaving the station or diverting of to another path at switch. Terminals or those where trains have to reverse to go back b siding opportunities where you need the train to. Despite the passing siding they try to reserve the path to the next stop or signal on the way. Learn more about path reservation in the examples below.

You would need passing loops at 1 3 and 2 3 along the route based on how quickly the train can get there. All passing loops in tpf2 are dynamic so intended that the trains pass at line speed therefore each loop is effectively a small double track section so all trains should be signalled to go right or left into the loop. Signals in transport fever are path signals. You ll see without signals the line will just go back and forth on a single track but with a signal at each end of the double track section the line will go up one side and down the other.

I already prepurchased transport fever and tried out train fever a bit but found the system with signals to be very confusing. All passing by segments should work like roads do.